Outback F4-2.5L SOHC (2005)
Neutral Safety Switch: All Technical Service Bulletins
A/T - Inhibitor Switch Cover/Splash Fin Availability
NUMBER: 16-71-07
DATE: 02/15/08
APPLICABILITY:
2005-08MY Legacy/Outback w/4AT
SUBJECT:
Inhibitor Switch Cover/Splash Fin
INTRODUCTION
The purpose of this bulletin is to announce that an inhibitor switch cover and splash fin is now available. These parts were designed to prevent snow,
slush and ice from limiting movement of the gear selector lever when packed in the area around the inhibitor switch. These parts should only be installed
on vehicles that may experience this type of issue.
PART INFORMATION
Note:
The 2 bolts that secure the AT Cable Plate Assembly will be reused. The AT Cable Bracket and 2 bolts will be reused.
Installation Instructions for Inhibitor Switch Cover
Note:
The following procedure is performed with the transmission in the vehicle.
Note:
Do not move Range selector or AT gearshift when performing the following procedure.
1)
Remove the snap pin and washer from the range select lever and remove cable.