Outback F4-2.5L SOHC (2005)
5. Install the ST on rack, and equally apply a thin coat of grease to the rack and ST, then install the oil seal.
ST 926250000 GUIDE
CAUTION: Be careful not to scratch the oil seal lips with the inner ring section of piston.
6. Apply a coat of grease to the grooves in rack, sliding surface of sleeve and sealing surface of piston. Then insert the rack into steering body from
cylinder side.
7. Check the thread part of holder and end of gearbox cylinder for burrs and scratches. Correct if necessary.
8. Insert the ST into gearbox cylinder, and then press-fit the oil seal.
ST 34199AG010 INSTALLER
9. Temporarily install the holder to gearbox cylinder.
10. Set the ST to the end of rack.
ST 34099FA030 INSTALLER & REMOVER
11. Using a press, press-fit until the groove of ST reaches the end of holder.