subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

Steering Gear|Removal|Page 5168 > < Steering Gear|Removal|Page 5166
Page 28
background image

18. Install the steering wheel.
19. Connect the battery ground cable to battery.
20. Pour fluid into the oil tank, and bleed air.
21. Check for fluid leaks.
22. Check the fluid level in oil tank.

23. After adjusting toe-in and steering angle, tighten the lock nut on tie-rod end.

Tightening torque: 85 Nm (8. 7 kgf-cm, 62.7 ft. lbs.)

NOTE:  When adjusting toe-in, hold the boot as shown to prevent it from being rotated or twisted. If twisted, straighten it.

Adjustment

Steering Gearbox 

ADJUSTMENT

1. Adjust the front toe.

Standard of front toe: IN 3-OUT 3 mm (IN 0.12-OUT 0.12 inch)

2. Adjust the steering angle of wheels.

Standard of steering angle:

3. If the steering wheel spokes are not horizontal when wheels are set in the straight ahead position, and error is more than 5° on the periphery of

Steering Gear|Removal|Page 5168 > < Steering Gear|Removal|Page 5166