Outback F4-2.5L SOHC (2005)
CAUTION:
-
Do not get closer the tool which charged magnetism to magnetic encoder.
-
Be careful not to damage the magnetic encoder.
8. Remove the front hub unit bearing. If it is hard to remove, use STs.
ST1 926470000 AXLE SHAFT PULLER
ST2 927140000 AXLE SHAFT PULLER PLATE
INSTALLATION
1. Place the disc cover between housing and front hub unit, and tighten the four bolts.
Tightening torque: 65 Nm (6.6 kgf-cm, 47.9 ft. lbs.)
2. Install the front drive shaft.
3. Tighten the axle nut temporarily.
4. Install the disc rotor on hub.
5. Install the disc brake caliper on the housing.
Tightening torque: 78 Nm (8.0 kgf-cm, 57.9 ft. lbs.)
6. While depressing the brake pedal, tighten a new axle nut (olive color) to specified torque and lock it securely.
Tightening torque: 220 Nm (22.4 kgf-cm, 162 ft. lbs.)
CAUTION:
-
Install the wheel after installation of the axle nut. Failure to follow this rule may damage the wheel bearing.
-
Be sure to tighten the axle nut to specified torque. Do not overtighten it as this may damage wheel bearing.