Outback F4-2.5L SOHC (2005)
Tightening torque: 5 Nm (0.5 kgf-cm, 3.6 ft. lbs.)
6. Install the front vehicle speed sensor and torque converter turbine speed sensor.
Tightening torque: 7 Nm (0.7 kgf-cm, 5.1 ft. lbs.)
7. Connect the connector to rear vehicle speed sensor.
8. Install the oil cooler pipe.
NOTE: Use a copper washer.
Tightening torque:
T1: 25 Nm (2.5 kgf-cm, 18 ft. lbs.)
T2: 44 Nm (4.5 kgf-cm, 32.5 ft. lbs.)
9. Install the transmission rear crossmember bolt.
Tightening torque: 75 Nm (7.6 kgf-cm, 55 ft. lbs.)
10. Install the propeller shaft.
11. Install the shield cover.
12. Install the front, center and rear exhaust pipes and muffler
13. Lower the vehicle.
14. Install the transmission connector to the stay.
15. Install the pitching stopper.
16. Install the air intake chamber.
17. Fill the same amount of ATF, drained.
18. Bleed the air of control valve.
19. Check the level of ATF.
20. Execute the learning control promotion.