Outback F4-2.5L SOHC (2005)
TRANSMISSION REAR CROSSMEMBER AND REAR CUSHION RUBBER
1. Install the rear cushion rubber.
Tightening torque: 40 Nm (4.1 kgf-cm, 29.5 ft. lbs.)
2. Install the crossmember.
Tightening torque:
T1: 35 Nm (3.6 kgf-cm, 26 ft. lbs.)
T2. 75 Nm (7.6 kgf-cm 55 ft. lbs.)
3. Remove the transmission jack.
4. Install the heat shield cover.
5. Install the front, center and rear exhaust pipes and muffler.
INSPECTION
Repair or replace parts if the results of the inspection below are not satisfied.
PITCHING STOPPER
Make sure that the pitching stopper is not bent or damaged. Ensure there are no cracks, hardening, or damage on rubbers.
TRANSMISSION REAR CROSSMEMBER AND REAR CUSHION RUBBER
Make sure that the crossmember is not bent or damaged. Ensure there are no cracks, hardening, or damage on cushion rubbers.