Outback F4-2.5L SOHC (2005)
21. Disconnect the harness connector and transmission ground terminal.
22. Remove the harness assembly.
INSTALLATION
1. Pass the harness assembly through the hole in transmission case.
2. Connect the harness connector and transmission ground.
Tightening torque: 8 Nm (0.8 kgf-cm, 5.8 ft. lbs.)
3. Apply proper amount of liquid gasket to the entire oil pan mating surface.
Liquid gasket: THREE BOND 1217B (Part No. K0877YA020)
4. Apply liquid gasket fully to the three holes other than screw holes on the transmission case
Liquid gasket: THREE BOND 1217B (Part No. K0877YA020)
5. Install the oil pan.