Outback F4-2.5L SOHC (2005)
NOTE: Use specified grease. PTJ side: NSG301 (Part No. 28395AG020)
1. Place the PTJ boot at the center of shaft.
2. Align alignment marks and install the trunnion on the shaft.
3. Install the snap ring to shaft.
CAUTION: Confirm that the snap ring is completely fitted in shaft groove.
4. Fill 100 to 110 g (3.53 to 3.88 oz.) of specified grease into the interior of PTJ outer race.
5. Apply a thin coat of specified grease to the roller kit and trunnion.
6. Align alignment marks on roller kit and trunnion and install the roller kit.
CAUTION: Be careful with the roller kit position.
7. Align alignment marks on the shaft and outer race, and install outer race.
8. Install the snap ring in the groove on PTJ outer race.
CAUTION: Pull the shaft lightly and assure that the snap ring is completely fitted in the groove.
9. Apply an even coat of the specified grease 30 to 40 g (1.06 to 1.41 oz.)to the entire inner surface of boot.
10. Install the PTJ boot taking care not to twist it.
CAUTION:
^
The large end of PTJ boot and the boot groove shall be cleaned completely so as to be free from grease and other substances.
^
When installing PTJ boot, position outer race of PTJ at center of its travel.