Outback F6-3.0L (2003)
(cross-section A).
NOTE: If two nuts are loosened at the same time, sash moves back and forth. Therefore, when one nut is adjusted, secure the other.
9. Make the same adjustment of two adjusting bolts of rear sash.
CAUTION: Do not tilt sash bracket to inner panel during adjustment. Otherwise smooth regulator operation cannot be achieved.
10. Make adjustment of front sash in the same manner as that of rear sash.
CAUTION: Although front and rear sashes must, as a rule, be adjusted in the same manner, in some door installation, the adjustment in a
different manner may be required. However, adjustment of one sash to the maximum amount and the other to the minimum amount is not
permitted. Such adjustment may result in application of excessive load to regulator.
11. After adjustments, tighten nuts.
12. After adjustment of glass, if there is a gap between outer lip of gusset and glass surface, adjust the gap with adjusting bolt (A) in lower fitting part
of gusset to prevent generation of wind noise.