Outback F6-3.0L (2003)
2. On the <<System Selection Menu,, display screen, select {Brake Control System} and press <<YES>> key.
3. Press the <<YES>> key after the VDC type is displayed.
4. On the <<Brake Control Diagnosis>> display screen, select {Current Data Display & Save} and press the <<YES>> key.
5. On the <<Data Display Menu>> display screen, select {Data Display} and press the <<YES>> key.
6. Using the scroll key, move the display screen up or down until the desired data is shown.
^
A list of the support data is shown in the following table.
NOTE: For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
CLEAR MEMORY MODE
1. On the <<Main Menu,, display screen, select {2. Each System Check} and press the <<YES>> key.
2. On the <<System Select Menu>> display screen, select {Brake System} and press the <<YES>> key.
3. Press the <<YES'' key after the engine type is displayed.
4. On the <<Brake Control Diagnosis>> display screen, select {Clear Memory} and press the <<YES>> key.
5. When 'Done' and turn ignition switch OFF' are shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF.
NOTE: For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
FUNCTION CHECK
Without Subaru Select Monitor
Read Diagnostic Trouble Code (DTC)
OPERATION