Outback F6-3.0L (2003)
^
The brake hose must be connected without any twist.
^
Replace brake hose gaskets with new ones.
7. Bleed air from brake system
DISASSEMBLY
1. Remove the boot ring.
2. Remove the piston boot.
3. Gradually supply compressed air via inlet of caliper body to force piston out.
CAUTION:
^
Place a wooden block as shown in Figure to prevent damage to piston.
^
Do not apply excessively high-pressure.
4. Remove piston seal from caliper body cylinder.
5. Remove lock pin sleeve and boot from caliper body.
6. Remove guide pin boot.
ASSEMBLY
1. Clean caliper body interior using brake fluid.
2. Apply a coat of brake fluid to piston seal and fit piston seal in groove on caliper body.
3. Apply a coat of brake fluid to the entire inner surface of cylinder and outer surface of piston.
