Outback F6-3.0L (2003)
^
Put a mark etc., to distinguish IN, OUT on pipe and hose.
6. Remove oil filter bracket installation nut.
7. Remove ATF filter assembly.
8. Remove ATF filter with attachment to bracket.
9. Get new ATF filter and apply a thin coat of ATF to the oil seal.
INSTALLATION
EXCEPT 3.0 L MODEL
1. Get new ATF filter and apply a thin coat of ATF to the oil seal.
2. Install ATF filter. Turn it by hand, being careful not to damage oil seal.
3. Using ST, tighten ATF filter to transmission case. Calculate ATF filter torque specifications using the following formula.
T2 = L2/(L1 + L
2. x T1
T1: 14 Nm (1.4 kgf-m, 10.1 ft. lbs.)
[Required torque setting]
T2: Tightening torque
L1: ST length 0.078 m (3.07 inch)
L2: Torque wrench length
Example:
NOTE: Align ST with torque wrench while tightening ATF filter.
ST 498545400 OIL FILTER WRENCH
4. Add ATF.
5. Inspect level of ATF.
3.0 L MODEL
^
ATF Filter
1. Get new ATF filter and apply a thin coat of ATF to the oil seal.
2. Install AT oil filter. Turn it by hand, being careful not to damage oil seal.
3. Using ST, tighten AT oil filter to attachment. Calculate AT filter torque specifications using the following formula.
T2 = L2/(L1 + L
2. x T1
T1: 14 Nm (1.4 kgf-m, 10.1 ft. lbs.)
[Required torque setting]
T2: Tightening torque
L1: ST length 0.078 m (3.07 inch)
L2: Torque wrench length
Example: