Outback F6-3.0L (2003)
Clutch Switch: Service and Repair
CLUTCH SWITCH
REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the instrument panel lower cover.
3. Disconnect the connector from clutch switch.
4. Remove the clutch switch.
INSTALLATION
CLUTCH SWITCH (WITH CRUISE CONTROL)
1. Install the clutch switch and clutch pedal stopper so that the gap between them is O mm (O inch).
Tightening torque: 8 Nm (0.8 kgf-m, 5.8 ft. lbs.)
2. Measure stroke of clutch pedal.
Specified clutch pedal full stroke: A 130 - 135 mm (5.12 - 5.31 inch)
3. If the clutch pedal stroke is out of specification, adjust the stroke.
4. Connect clutch switch connector.
CLUTCH SWITCH (STARTER INTERLOCK)
1. Fully depress the clutch pedal.