Outback F6-3.0L (2003)
Steering Gear: Service and Repair
Disassembly and Assembly
Steering Gearbox
DISASSEMBLY
RACK HOUSING ASSEMBLY
1. Disconnect four pipes from gearbox.
2. Secure gearbox removed from vehicle in vise using ST.
ST 926200000 STAND
CAUTION: Secure the gearbox in a vise using the ST as shown. Do not attempt to secure it without this ST.
3. Remove tie-rod end and lock nut from gearbox.
4. Remove small clip from boot using pliers, and move boot to tie-rod end side.
5. Remove boot with large clips.
6. Extend rack approximately 40 mm (1.57 inch) out. Unlock lock wire at lock washer on each side of tie-rod end using a standard screwdriver.
CAUTION: Be careful not to scratch rack surface as oil leaks may result.