Outback F6-3.0L (2003)
3. Remove two bolts securing valve assembly.
4. Carefully draw out input shaft and remove valve assembly.
5. Draw out pinion and valve assembly from valve housing, using pipe of I.D. 44 to 46 mm (1.73 to 1.81 inch) and a press.
6. Pry off dust seal using screwdriver.
7. Remove snap ring using snap ring pliers.
8. Pry off oil seal using screwdriver.
CAUTION: After removing, check inside surface of valve housing for damage. If oil seal contacting surface is damaged, replace valve housing
with a new one.
9. Remove snap ring using snap ring pliers.