Outback F6-3.0L (2003)
Valve Body: Service and Repair
Transfer Duty Solenoid and Valve Body
Transfer Duty Solenoid and Valve Body
REMOVAL
1. Set the vehicle on a lift.
2. Disconnect the ground cable from battery.
3. Remove the air cleaner case. (2.5 L model)
4. Remove air intake chamber. (3.0 L model)
5. Remove the pitching stopper.
6. Remove the front exhaust pipe with center exhaust pipe.
7. Remove the rear exhaust pipe and muffler.
8. Raise the vehicle and drain the ATF.
9. Remove the heat shield cover.
10. Remove the propeller shaft.
11. Remove the transmission rear crossmember.
1. Support the transmission using a transmission jack and raise slightly.
2. Remove the bolts and nuts as shown in the figure.
12. Remove the rear vehicle speed sensor.