Outback F6-3.0L (2003)
2. Install a new gasket and the extension case to transmission case.
1. Tighten eleven bolts.
Tightening torque: 25 Nm (2.5 kgf-m, 18.1 ft. lbs.)
2. Adjust the select cable.
3. Install the rear vehicle speed sensor.
Tightening torque: T: 7 Nm (0. 7 kgf-m, 5.1 ft. lbs.)
4. Install the transmission rear crossmember.
1. Tighten the bolts.
Tightening torque:
T1: 35 Nm (3.6 kgf-m, 26 ft. lbs.)
T2: 70 Nm (7.1 kgf-m, 51 ft. lbs.)
2. Remove the transmission jack.
5. Install the propeller shaft.
6. Install the front, center rear exhaust pipe and muffler.
7. Connect the transmission harness connector.
8. Install the pitching stopper.
Tightening torque:
T1: 50 Nm (5.1 kgf-m, 37 ft. lbs.)
T2: 58 Nm (5.9 kgf-m, 43 ft. lbs.)
9. Install the air cleaner case.
10. Install air intake chamber. (3.0 L model)
11. Fill ATF up to the middle of the "COLD" side on level gauge by using the gauge hole.
12. Check the ATF level.