Outback F6-3.0L DOHC (2006)
Rear Door Panel: Service and Repair
Rear Sealing Cover
REAR SEALING COVER
REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the rear door trim.
3. Pull back the sealing cover.
NOTE:
-
Carefully remove the butyl tape. Excessive force will easily break the cover.
-
If cover is broken, replace it with a new one.
INSTALLATION
1. Install in the reverse order of removal.
2. When replacing the sealing cover, use butyl tape.
3. Press the butyl tape-applied area firmly to prevent any floating on surface.
Butyl tape: 3M 8626 or equivalent
NOTE:
-
Apply a uniform bead of butyl tape.
-
Attach the sealing cover, keeping it from becoming wrinkled.
-
Breaks in the bead will allow water leakage and contamination.