Outback F6-3.0L DOHC (2006)
Rear Shelf: Service and Repair
REAR SHELF TRIM
REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the rear quarter trim.
3. Remove the high-mounted stop light.
4. Remove the rear seat cushion.
5. Remove the lower anchor bolt of rear center seat belt.
6. After disconnecting the high-mounted stop light harness connector (A) and removing the five clips, remove the rear shelf trim with pulling it
frontward.
INSTALLATION
Install in the reverse order of removal.
NOTE: Securely insert the vehicle body panel into the hook of rear shelf trim center, and then install the rear shelf trim.
