Outback F6-3.0L DOHC (2006)
8. Remove the adjuster assembly from parking brake assembly.
9. Remove the brake shoe.
10. Remove the rear shoe hold down spring and pin with pliers.
11. Remove the parking brake cable from lever.
12. Using a flat tip screwdriver, raise the retainer. Remove the parking lever and washer from brake shoe.
INSTALLATION
CAUTION: Be sure the lining surface is free from oil and grease contamination.
1. Apply brake grease to the following places.
Brake grease: Brake Grease (Part No. 003602002)
^
Six contact surfaces of shoe rim and back plate packing
^
Contact surface of shoe wave and anchor pin
^
Contact surface of lever and strut
^
Contact surface of shoe wave and adjuster assembly
^
Contact surface of shoe wave and strut
^
Contact surface of lever and shoe wave
2. Insert the primary side brake shoe into anchor pin groove.
3. Secure the brake shoe with the shoe hold-down pin and cup.
4. Install the plate to anchor pin, and then assemble the primary return spring to anchor pin.
5. Install the parking brake cable to parking brake lever.
