Outback F6-3.0L DOHC (2006)
NOTE:
^
When installing the clutch cover to the flywheel, position the clutch cover in order to make the gap between imbalance marks (40 paint mark)
of flywheel and clutch cover 120° or more. (The imbalance marks show the residual imbalance direction.) - Note the front and rear of the
clutch disc when installing.
^
Tighten the clutch cover installing bolts gradually. Each bolt should be tightened to the specified torque in a crisscross order.
Tightening torque: 16 Nm (1.6 kgf-m, 11.8 ft. lbs.)
3. Remove the ST.
ST 499747100 CLUTCH DISC GUIDE
4. Install the transmission assembly.
INSPECTION
NOTE: The illustration below is for a Non-turbo model. However, perform the same procedures for the Turbo model.
1. CLUTCH DISC
1. Facing wear: Measure the depth from the facing surface to the rivet head. Replace if the face is worn locally or worn down to less than the
specified value.
Depth to rivet head: Limit of sinking 0.3 mm (0.012 inch)
NOTE: Do not wash the clutch disc with any type of cleaning fluid.
2. Hardened facing Replace the clutch disc.
3. Oil soakage on facing Replace the clutch disc and inspect the transmission front oil seal, transmission case mating surface, engine rear oil seal and
other locations for oil leakage.
