Outback F6-3.0L DOHC (2006)
ASSEMBLY
1Attacht the hub to the ST securely.
ST 927080000 HUB STAND
2. Using a press, Press the new hub bolts until their seating surfaces contact the hub.
NOTE: Use the 12 mm (0.47 inch) dia. holes in the HUB STAND to prevent bolts from tilting.
INSPECTION
1. Moving the rear tire up and down by hand, check there is no backlash in bearing, and check the wheel rotates smoothly.
2. Inspect the lean of axis direction using a dial gauge. Replace the hub bearing if the play exceeds the limit value.
Service limit.
Maximum: 0.05 mm (0.0020 inch)