Outback L.L.Bean Edition AWD F6-3.0L (2002)
Idle Speed/Throttle Actuator - Electronic: Service and Repair
REMOVAL
1. Disconnect battery ground cable.
2. Disconnect connector (A) from idle air control solenoid valve.
3. Disconnect air by-pass hose (B) from idle air control solenoid valve.
4. Remove idle air control solenoid valve from throttle body.
INSTALLATION
Install in the reverse order of removal.
NOTE: Replace gasket with a new one.
Tightening Torque: 2.8 Nm (0.29 kgf-m, 2.1 ft-lb)
