Outback L.L.Bean Edition AWD F6-3.0L (2002)
ST2 927390000 ADAPTER
CAUTION: Do not hammer drive shaft when installing it.
3. Tighten axle nut temporarily.
4. Install SFJ on transmission spindle and drive spring pin into place.
CAUTION: Always use a new spring pin.
5. Connect transverse link to housing.
Tightening torque (self-locking nut): 49 Nm (5.0 kgf-cm, 36 ft. lbs.)
CAUTION: Use a new self-locking nut.
6. Install stabilizer bracket.
7. While depressing brake pedal, tighten axle nut to the specified torque.
Tightening torque: 216 Nm (22 kgf-cm, 159 ft. lbs.)
CAUTION:
^
Use a new axle nut (3.0 ~ model: Olive color, 2.5 ~ model: Gold color).
^
Always tighten axle nut before installing wheel on vehicle. If wheel is installed and comes in contact with ground when axle nut is loose, wheel
bearings may be damaged.
^
Be sure to tighten axle nut to specified torque. Do not overtighten it as this may damage wheel bearing.
8. After tightening axle nut, lock it securely.
Disassembly and Assembly
DISASSEMBLY
1. Place alignment marks on shaft and outer race.
2. Remove SFJ boot band and boot.
CAUTION: Be careful not to damage boot.