Outback L.L.Bean Edition AWD F6-3.0L (2002)
4. Using ST1 and ST2, pull axle shaft into place.
ST1 922431000 AXLE SHAFT INSTALLER
ST2 927390000 ADAPTER
5. Temporarily tighten axle nuts.
6. Install disc rotor on hub.
7. Install disc brake caliper on back plate.
Tightening torque: 52 Nm (5.3 kgf-cm, 38.3 ft. lbs.)
8. Install rear ABS sensor and brake cable bracket.
9. Adjust parking brake lever stroke by turning adjuster.
10. Move brake lever back to apply brakes. While depressing brake pedal, tighten axle nut using a socket wrench. Lock axle nut after tightening.
Tightening torque: 235 Nm (24 kgf-cm, 174 ft. lbs.)
CAUTION:
^
Use a new axle nut for rear use only (Olive color).
^
Always tighten axle nut before installing wheel on vehicle. If wheel is installed and comes in contact with ground when axle nut is loose, wheel
bearings may be damaged.
^
Be sure to tighten axle nut to specified torque. Do not overtighten it as this may damage wheel bearing.
11. Install wheel and tighten wheel nuts to specified torque.
Tightening torque: 88 Nm (9 kgf-cm, 65 ft. lbs.)
