Outback L.L.Bean Edition AWD F6-3.0L (2002)
3. Mount each part; boot, O-ring, bushing A, spacer, bushing, bushing B and spring pin on the gear shift lever.
NOTE:
^
Always use new O-rings.
^
Apply grease [NIGTIGHT LYW No. 2 or equivalent] to the inner and side surfaces of the bushing when installing the spacer.
4. Insert gear shift lever into the boot hole.
5. Install snap ring and stay to the bushing B.
6. Tighten with lock wire to the extent that the boot will not come off.
NOTE: Always use new lock wire.
7. Insert the rod into the boot hole.
