Outback L.L.Bean Edition AWD F6-3.0L (2002)
1. Install the pitching stopper.
Tightening torque:
T1: 50 Nm (5.1 kgf-cm, 37 ft. lbs.)
T2: 58 Nm (5.9 kgf-cm, 43 ft. lbs.)
2. Install the cleaner case.
3. Connect battery ground cable.
2. CROSSMEMBER AND CUSHION RUBBER
1. Install the rear cushion rubber.
Tightening torque: 35 Nm (3.6 kgf-cm, 26 ft. lbs.)
2. Install the crossmember.
Tightening torque:
T1: 75 Nm (7.6 kgf-cm, 55 ft. lbs.)
T2: 140 Nm (14.3 kgf-cm, 103 ft. lbs.)
3. Remove the transmission jack.
4. Install the heat shield cover.
5. Install the front, center, rear exhaust pipes and the muffler.