Outback L.L.Bean Edition AWD F6-3.0L (2002)
4. Install baulk ring, needle bearing, 4th drive gear and 4th gear thrust washer to transmission main shaft.
NOTE: Align baulk ring and gear & hub assembly with key groove.
5. Drive ball bearing onto the rear section of transmission main shaft using ST1, ST2 and a press.
CAUTION: Do not apply pressure in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
6. Using ST1 and ST2, install the 5th gear thrust washer and 5th needle bearing race onto the rear section of transmission main shaft.
CAUTION: Do not apply pressure in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).
NOTE: Face thrust washer in the correct direction.
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
7. Install bearing onto synchro cone.