Outback L.L.Bean Edition AWD F6-3.0L (2002)
Wiper Motor: Service and Repair
Rear Wiper Motor
Rear Wiper Motor
REMOVAL
1. Remove rear wiper arm.
2. Remove cap (A), nut (B), and spacer (C) from rear wiper shaft.
3. Remove rear gate lower trim.
4. Remove harness clip and disconnect wiper motor connector.
5. Loosen bolts to remove wiper motor assembly (A).
INSTALLATION
1. Install in the reverse order of removal.
2. Install rear wiper cushion with the arrow mark facing up, as shown.
Tightening torque: Refer to COMPONENT in General Description.