Outback [Legacy] AWD F4-2.5L DOHC (1996)
CAUTION: Do not reconnect airbag connector at steering column until airbag control module is securely re-installed.
4. Remove console box.
5. Disconnect 12-pin yellow, 2-pin blue and 2-pin orange connectors from airbag control module.
6. Using TORX© BIT T40 (Tamper resistant type), remove two TORX© bolts.
Discard the old TORX© bolts.
CAUTION: Use new TORX© bolts during re-assembly.
INSTALLATION
Installation is in reverse order of removal procedures.
CAUTION: Be sure to fully secure all airbag system connectors during re-assembly and confirm that all green double lock mechanisms are engaged.
