Outback [Legacy] AWD F4-2.5L DOHC (1996)
4) Remove ST3, and fit backing washer.
ST1 926370000 INSTALLER A
5T2 927630000 STAND BASE
ST3 926360000 INSTALLER A
ST4 927620000 INSTALLER B
5) Force-fit ball bearing using ST3.
ST1 926370000 INSTALLER A
ST2 927630000 STAND BASE
ST3 927640000 INSTALLER B
NOTE: Be careful not to tilt ball bearing during installation.
6) Install snap ring using snap ring pliers.
NOTE: Rotate snap ring to check for proper installation.
Rack Housing Oil Seal And Back-up Washer
-
Removal
Insert a round rod [26 - 27 mm (1.02 - 1.06 in) dia.] from pinion housing side and remove oil seal and back-up washer by hammering the rod.
NOTE:
-
Discard removed oil seal and back-up washer.
-
Apply the unchamfered end of remover to back-up washer.
-
Installation
Force-fit oil seal and back-up washer using ST. ST 927650000 INSTALLER
CAUTION: Be careful not to damage or scratch cylinder inner wall.
NOTE;
-
Apply ATF DEXRON II to oil seal.
-
Pay special attention not to install back-up washer and oil seal in wrong direction.