Outback Limited Wagon AWD F4-2.5L SOHC (2002)
Canister Purge Solenoid: Service and Repair
Removal and Installation
Purge Control Solenoid Valve
REMOVAL
1. Disconnect battery ground cable.
2. Remove bolt which installs purge control solenoid valve onto intake manifold.
3. Take out purge control solenoid valve through the bottom of the intake manifold.
4. Disconnect connector and hoses from purge control solenoid valve.
INSTALLATION
1. Install in the reverse order of removal.
Tightening torque: 16 Nm (1.6 kgf-m, 11.6 ft-lb)