Outback Sport F4-2.5L (2010)
Clutch Disc: Service and Repair
Clutch Disc and Cover
REMOVAL
1) Remove the transmission assembly from the vehicle.
2) Attach the ST on the flywheel.
ST 499747100 CLUTCH DISC GUIDE
3) Remove the clutch cover and clutch disc.
NOTE:
^
Take care not to allow oil to touch the clutch disc face.
^
Do not disassemble the clutch cover or clutch disc.
INSTALLATION
1) Insert the ST into the clutch disc and attach to the flywheel by inserting the ST end into pilot bearing.
NOTE:
When installing the clutch disc, be careful to attach in the correct direction.
ST 499747100 CLUTCH DISC GUIDE
2) Install the clutch cover to the flywheel and tighten the bolts to the specified torque.
NOTE:
^
When installing a clutch cover to the flywheel, position the clutch cover so that the spacing between the unbalance marks (paint mark) on the
flywheel and clutch cover is 120 degrees or more apart. (The unbalance mark indicates the direction of residual unbalance.)
^
Note the front and rear of the clutch disc when installing.
^
Temporarily tighten the bolts by hand. Each bolt should be tightened to the specified torque in a crisscross order.
