Outback Sport F4-2.5L SOHC (2005)
NOTE: Ensure the letter8 on each clamp are diagonally opposite each other as shown in the figure.
5. Tighten the clamp E firmly.
Tightening torque: 7.4 Nm (0.75 kgf-m, 5.4 ft. lbs.)
6. Tighten the joint nut.
Tightening torque: 15 Nm (1.5 kgf-m, 10.8 ft. lbs.)
7. Connect the pipes A and B to four pipe joints of gearbox. Connect the upper pipe B first, and lower pipe A second.
Tightening torque:
Non-turbo model: 13 Nm (1.3 kgf-m, 9.4 ft. lbs.)
Turbo model and STi model:
Housing side: 20 Nm (2.0 kgf-m, 14.5 ft. lbs.)
Cylinder side: 24 Nm (2.4 kgf-m, 17.4 ft. lbs.)
8. Install the jack-up plate.
9. Install the air intake duct.
10. Install the air intake duct, air cleaner upper cover and air intake boot.
11. Connect the battery ground cable to battery.
12. Feed the specified fluid.
CAUTION: Never start the engine before feeding the fluid; otherwise vane pump might be seized up.
