Outback VDC Wagon AWD F6-3.0L (2002)
Cleaning Procedure: Turbo Vehicles
1) Warm up engine.
2) Remove the intercooler and set aside.
3) Disconnect the Mass Airflow sensor connector.
4) Cycle the key "on/off" once (to enter "failsafe" mode).
5) Start the car and maintain engine speed between 1000-1500 rpm.
6) Spray engine cleaner (GM Part # 12345089 Top Engine Cleaner or equivalent) on the upper air-stream of the throttle chamber for approximately
10 seconds.
7) Stop engine and let sit for 3 minutes.
8) Restart the engine and maintain 1000 to 1500 rpms.
9) Spray engine cleaner on the upper air-stream of the throttle chamber for approximately 10 seconds.
10) Turn engine off.
11) Reinstall intercooler and reconnect Mass Airflow sensor connector.
12) Operate car between 1000-2000rpms until no white smoke appears through tailpipe.
13) Turn ignition switch off and clear memory.