Outback VDC Wagon AWD F6-3.0L (2002)
2. Set fuel saucer (A) with rubber packing (C) and insert fuel filler pipe into hole from the inner side of apron.
3. Align holes in fuel filler pipe neck and set cup (B), and tighten screws.
NOTE: If edges of rubber packing are folded toward the inside, straighten it with a screwdriver.
4. Tighten bolt which holds fuel filler pipe on body.
Tightening Torque: 7.5 Nm (0.75 kgf-m, 5.4 ft-lb)
5. Insert evaporation hose approximately 25 to 30 mm (0.98 to 1.18 in) into the lower end of evaporation pipe and hold clip.