Outback VDC Wagon AWD F6-3.0L (2002)
4. Attach ST to front body. Using a press, install oil seal.
ST 341 99AE030 INSTALLER
5. Install pump pulley to front body.
6. Using ST, place oil pump in a vise.
ST 341 99AE020 ATTACHMENT
7. Remove rear cover.
8. Using 10-mm box wrench, tap retaining ring into shaft groove.
9. Install pressure plate as shown in the figure.
10. Apply specified hydraulic oil to O-rings and fit them into front casing and pressure plate.
11. Install seal ring to pressure plate.
12. With knock pin positions aligned, install rear cover.
Tightening torque: 27.5 Nm (2.8 kgf-m, 20.3 ft. lbs.)
CAUTION: Loosely tighten bolts in the sequence (A), (B), (C), and (D) shown in figure. Then, tighten in the same sequence.
13. When reassembly procedures have been completed, turn shaft by hand to ensure it turns smoothly. If it binds or other unusual conditions are
evident, disassemble again and check for foreign matter trapped on sliding surfaces and improper installation. Eliminate the cause of trouble.
14. Check followings by referring to "CHECK" article.
^
Excessive play in pulley shaft
^
Ditch deflection of pulley