Outback VDC Wagon AWD F6-3.0L (2002)
ST 499747100 CLUTCH DISC GUIDE
2. Install clutch cover on flywheel and tighten bolts to the specified torque.
NOTE:
^
When installing the clutch cover on the flywheel, position the clutch cover so that there is a gap of 120° or more between "0" marks on the
flywheel and clutch cover. ("0" marks indicate the directions of residual unbalance.)
^
Note the front and rear of the clutch disc when installing.
^
Temporarily tighten bolts by hand. Each bolt should be tightened to the specified torque in a crisscross fashion.
Tightening torque: 15.7 Nm (1.6 kgf-cm, 11.6 ft. lbs.)
3. Remove ST. ST 499747100 CLUTCH DISC GUIDE
4. Install transmission assembly.