Outback VDC Wagon AWD F6-3.0L (2002)
10. Align alignment marks and install trunnion on shaft.
11. Install snap ring to shaft.
CAUTION: Confirm that the snap ring is completely fitted in the shaft groove.
12. Fill 100 to 110 g (3.53 to 3.88 oz) of specified grease into the interior of SFJ outer race.
13. Apply a coat of specified grease to free ring and trunnion.
14. Align alignment marks on free ring and trunnion and install free ring.
CAUTION: Be careful with the free ring position.
15. Align alignment marks on shaft and outer race, and install outer race.
16. Install circlip in the groove on SFJ outer race.
CAUTION: Pull the shaft lightly and assure that the circlip is completely fitted in the groove.
17. Apply an even coat of the specified grease 30 to 40 g (1.06 to 1.41 oz) to the entire inner surface of boot.
18. Install SFJ boot taking care not to twist it.
CAUTION:
^
The inside of the larger end of SFJ boot and the boot groove shall be cleaned so as to be free from grease and other substances.
^
When installing SFJ boot, position outer race of SFJ at center of its travel.
19. Put a band through the clip and wind twice in alignment with band groove of boot.