Outback VDC Wagon AWD F6-3.0L (2002)
4. Align the holes in rod and fork, and new drive straight pin into these holes using ST.
NOTE:
^
Set other rods to neutral.
^
Make sure interlock plunger is on the 3-4 fork rod side.
ST 398791700 STRAIGHT PIN REMOVER
5. Install interlock plunger onto 3-4 fork rod.
NOTE: Apply a coat of grease to plunger to prevent it from falling.
6. Install 3-4 fork rod into 3-4 shifter fork via the hole on the rear of transmission case.
7. Align the holes in rod and fork, and new drive straight pin into these holes.
NOTE:
^
Set reverse fork rod to neutral.
^
Make sure interlock plunger (installing before) is on the reverse fork rod side.
ST 398791700 STRAIGHT PIN REMOVER
8. Install 5th shifter fork onto the rear of reverse fork rod. Align holes in the two parts and new drive straight pin into place.
ST 398791700 STRAIGHT PIN REMOVER
9. Position balls, checking ball springs and new gaskets into 3-4 and 1-2 rod holes, and install plugs.
10. Install differential assembly.
11. Install main shaft assembly.
12. Install drive pinion shaft assembly.
13. Install transmission case.
14. Install transfer case with extension case assembly.
15. Install back-up light switch and neutral position switch.
16. Install the manual transmission assembly to vehicle.
