Outback VDC Wagon AWD F6-3.0L (2002)
1. Assemble each sleeve and hub assembly.
NOTE: Position open ends of spring 120° apart.
2. Install 3rd drive gear, outer baulk ring, synchro cone, inner baulk ring, sleeve and hub assembly for 3rd needle bearing on transmission main shaft.
NOTE: Align groove in baulk ring with shifting insert.
3. Install 4th needle bearing race onto transmission main shaft using ST1, ST2 and a press.
CAUTION: Do not apply pressure in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER