SVX L6-3.3L DOHC (1992)
Vacuum Brake Booster: Service and Repair
Removal/Installation
1.
Disconnect battery ground cable.
2.
Raise and support vehicle and remove front stabilizer bar.
3.
Drain approximately 1 quart of transmission fluid and loosen ATF level guide pipe bolts.
4.
Remove cruise control actuator.
5.
Disconnect positive terminal from starter motor.
6.
Disconnect low-pressure AC pipe.
7.
Disconnect vacuum hose from booster and remove master cylinder refer to MASTER CYLINDER.
8.
Remove snap pin, clevis pin and four brake booster to pedal bracket nuts, then the booster.
9.
Reverse procedure to install.