SVX L6-3.3L DOHC (1992)
e. Apply a coat of grease to guide surface, and install guide onto end of input shaft. Insert pinion and valve assy until "A" of oil seal contacts "B"
of valve housing. The guide is used to prevent scratching Y-packing.
f.
Secure input shaft with press and insert valve assy into valve housing. Do not allow spacer to extend beyond brazed end. Otherwise, pinion
cannot be inserted properly.
g. Apply a coat of grease to sealing lips of dust cover and insert dust cover until it contacts staged portion of input shaft.
Vehicle Speed Sensing, Electronic, Hydraulic Reaction Type
TOOL REQUIRED
^
34099PA070 Remover
^
926270000 Cover
^
927570000 Spacer
^
927530000Installer E
^
927520000 Installer D
^
927540000 Remover
DISASSEMBLE
NOTE: Leave the clips and wire wound up on the housing as is.
1. Removal of valve assy: