SVX FWD L6-3.3L DOHC (1994)
EGR Valve: Service and Repair
Intake Manifold
EGR VALVE REMOVAL
1.
Remove EGR fasteners.
2.
Disconnect vacuum hose.
3.
Reinstall in reverse order with new gasket.
FASTENER TORQUE VALUE
12.6 - 14.8 ft.lbs. (17 - 20 Nm)
EGR VALVE CLEANING
NOTE: Do not damage the EGR valve diaphragm by cleaning it with solvents. Do not clamp the valve in a vise. Always use a new gasket when
replacing valve.
1.
Hold EGR valve assembly and tap lightly with a small plastic hammer to remove deposits from the valve seat. Empty out loose particles.
2.
Clean deposits from around the mounting surface and valve with a wire wheel or other suitable tool.
3.
Depress the valve diaphragm. Check the valve seat area for cleanliness by looking through the valve outlet. If not completely clean, repeat step 1.
4.
Remove deposits from the valve outlet with a screwdriver or other suitable tool.
5.
Blow out small particles and dust with an air hose.
6.
Check valve operation with a hand vacuum pump. Replace the valve if it does not open completely.
EXHAUST GAS PASSAGE CLEANING
NOTE: Do not use an electric drill.