SVX FWD L6-3.3L DOHC (1994)
20. Remove parking brake lining and disconnect cable from lining
21. Remove parking brake cable clamp; remove cable from lining.
22. Remove BJ from housing If it is hard to remove, use remover and plate.
a. Be careful not to damage oil seal lip when removing BJ.
b. When replacing BJ, also replace inner oil seal with a new one.
23. Remove securing bolts and housing.
24. Install in reverse order of removal. For installation and tightening torque of suspension parts, refer to specification. For installation and tightening
torque of brake parts, refer to Brakes and Traction Control.
a. Be careful not to damage inner oil seal lip.
b. Use a new self-locking nut.
c. Use a new axle nut.
d. Always tighten axle nut before installing wheel on vehicle. If wheel is installed and comes in contact with ground when axle nut is loose, wheel
bearings may be damaged.
e. Be sure to tighten axle nut to specified torque. Do not overtighten it as this may damage wheel bearing.
f.
When front drive shaft is to be replaced, also replace inner oil seal with a new one.
25. After tightening axle nut, lock it securely.