SVX FWD L6-3.3L DOHC (1994)
7. Align alignment marks on free ring and trunnion, and install free ring
8. Align alignment marks on outer race and shaft and install outer race.
9. Install circlip in the groove on FTJ outer race Pull the shaft lightly and assure that the circlip is completely fitted in the groove.
10. Apply an even coat of the specified grease 30 to 40 g (1.06 to 1.41 oz) to the entire inner surface of boot.
11. Install FTJ boot taking care not to twist it.
a. The inside of the larger end of FTJ boot and the boot groove must be cleaned so as to be free from grease and other substances.
b. When installing FTJ boot, position outer race of FTJ at center of its travel.
12. Put a band through the clip and wind twice in alignment with band groove of boot. Use a new band.
13. Pinch the end of band with pliers. Hold the clip and tighten securely. When tightening boot, exercise care so that the air within the boot is
appropriate.
14. Tighten band by using band tightening tool.
a. Tighten band until it cannot be moved by hand.
b. Former band tightening tool is interchangeable with 925091000.
15. Tap on the clip with the punch provided at the end of band tightening tool. Tap gently so that the boot underneath is not damaged.
16. Cut off band with an allowance of about 10 mm (0.39 inch) left from the clip and bend this allowance over the clip. Make sure that the end of the
band is in close contact with clip.
17. Fix boot on BJ in the same manner. Extend and retract FTJ to provide equal grease coating.
18. Install remaining parts in reverse order of removal. For installation and tightening torque of suspension parts, refer to specification. For installation
and tightening torque of brake parts, refer to Brakes and Traction Control.
a. Use a new self-locking nut.
b. Make sure O-ring is properly installed on transmission spindle.
c. Apply a sufficient coat of grease to transmission spindle splices.
d. Always use new sealer-pack type spring pin.
