SVX FWD L6-3.3L DOHC (1994)
Wheel Bearing: Service and Repair
Front
TOOL REQUIRED
^
28099PA080 Hub Stand
^
28099PA040 Hub Remover "FRONT"
^
28099PA010 Housing Stand "FRONT"
^
28099PA000 Bearing Installer "FRONT"
^
28099PA030 Oil Seal Installer "FRONT"
^
28099PA020 Hub Installer "FRONT"
NOTE: Housing must be removed prior to service.
DISASSEMBLE
1. Using hub stand, support housing and hub assy securely.
2. Attach hub remover "FRONT" to housing and drive hub completely out. If inner bearing race remains in the hub, remove it with a suitable tool
(commercially available).
a. Be careful not to scratch polished area of hub.
b. Be sure to install inner race on the side of outer race from which it was removed.