SVX LSi AWD L6-3.3L DOHC (1997)
Alignment: Service and Repair
Preliminary Checks
Check, adjust and/or measure wheel alignment in accordance with procedures indicated:
Camber
1. Loosen two self-locking nuts located at lower front portion of strut.
a. When adjustment bolt needs to be adjusted, hold its head with a wrench and turn self-locking nut.
b. Discard old self-locking nut and replace with a new one.
2. While aligning scale for adjustment bolt (located at rear of vehicle) with mark on strut bracket, set camber angle within proper specifications.
3. Tighten two self-locking nuts. Tightening torque: 132 - 172 Nm (97.4 - 126.9 ft. lbs.)
Camber and Caster
TOOL REQUIRED
^
927380000 Adapter
1. Place the wheel to be measured on the turning radius gauge, and make sure the vehicle is level.
2. Set ADAPTER (927380000) into the center of the wheel, and then install the alignment gauge.
Toe-In
Measurement