SVX LSi AWD L6-3.3L DOHC (1997)
2. Using a press, force-fit the roller bearing in position. Do not change the relative positions of the outer race and bearing cone.
3. After fining the O-ring to the shaft, attach the drive pinion collar to the shaft. Be careful not to damage the O-ring.
4. Tighten the lock washer and lock nut to 108-118 Nm (80-87 ft.lb)
a. Pay attention to the orientation of lock washer.
b. When using special tool WRENCH (499787100) and torque wrench, tighten it to 88 Nm (65 ft.lb)
5. Measure the starting torque of the bearing. Make sure the starting torque is within the specified range. If out of the allowable range, replace the
roller bearing.
Starting torque: 0.3-2.0 Nm (2.6-17.4 ft.lb)
6. Stake the lock nut securely at two places.
7. Measure dimension "B" of the drive pinion shaft.
8. Determine the thickness t (mm) of the drive pinion shim.