SVX LSi AWD L6-3.3L DOHC (1997)
17. Cut off band with an allowance of about 10 mm (0.39 inch) left from the clip and bend this allowance over the clip. Be careful so that the end of
the band is in close contact with clip.
18. Fix up boot on BJ in the same manner.
19. Place protector onto BJ boot band. Extend and retract DOJ to provide equal grease coating. Discard circlip on left DOJ splice, and install new
one.
20. Using side oil seal protector, install DOJ into differential
21. Insert DOJ splined end into bore of oil side seal, and remove side oil seal protector. Do not allow DOJ splices to damage side oil seal.
22. Mesh DOJ with differential splines.
23. Push housing to insert DOJ into differential. Check to make sure DOJ is inserted properly.
24. Install remaining parts in reverse order of removal procedures.
25. For installation and tightening torque of suspension parts, refer to specification. For installation and tightening torque of brake parts, refer to
Brakes and Traction Control. Use a new self-lock nut.